Wednesday, April 10, 2013

Bearing Standard tolerance for shaft and Housing, Selection of general tolerance for machined components



The following procedure will tell, 

How to select general tolerance for machined components.


1. For discussion a bearing housing is considered with inner diameter turned to ΓΈ60mm.

  • To provide a tolerance to the diameter we have to select what kind of fit to be used.
  • Let us considered the load acting on the bearing inner ring is varying as shown below.

Table 1.1
For our case considered the shaft is transmitting Power therefore inner ring is rotating.
  • From Table 1.1, third operating condition the fit is selected as interference fir for Housing
  • Now from Table 1.2, for normal & heavy Duty the tolerance Class is selected as N7
Table 2
  • From Table 1.3, the Tolerance is selected as -0.039/-0.009
Table 3 
Sample dimensioning and Tolerances for a housing





How to select the general machining tolerance as per IS 2102 is discussed below.




2. For discussion a stepped shaft is taken as shown below.









  • From Table 2.1, given below Tolerances for linear dimensions can be arrived
Table 2.1 General Tolerance for Linear Dimensions
  • From Table 2.2-3, given below Tolerances for Fillets, Chamfers & Angles dimensions can be arrived
Table 2.2-3 General Tolerance for Fillet, Chamfer and Angular Dimensions
  • From the Given Table the tolerance for shaft for general Machining is selected and shown below (Note: this for a general machined shaft, cases where the shaft is going to be seat in bearing, a similar procedure as of housing has to be followed.) 




Sheet Metal Tolerance Standards 


How to select Sheet metal tolerance is discussed below


  • The main thing to be considered for selection of sheet metal tolerance is not just the Linear dimension as like IS 2102, the Reference from where to where the dimension take plays a vital role. Table 3.1 shown the unspecified Sheet metal Tolerance.
  • For edge to edge, hole to hole & edge to hole, tolerances shall be taken from column A
  • For edge to bend and hole to bend, tolerances shall be taken from column B
  • For bend to bend, tolerance shall be taken from column C
  • For Angular Tolerances ± 2 Degree shall be taken


Table 3.1 Sheet Metal  Tolerance for unspecified tolerances

How to select general tolerance for Welding.


Welding Tolerance shall be taken as per ISO 13920 

  • Welding Tolerance for Linear dimensions shall be taken from Table 4.1 
Table 4.1 Welding Tolerance for Linear Dimensions
  • Welding Tolerance for Angular dimensions shall be taken from Table 4.2, in a similar way as discussed in general Tolerance for machined component Discussion (2)
Table 4.2 Welding Tolerance for Angular Dimension


6 comments:

  1. For further query make a comment which will be replies by us.

    ReplyDelete
  2. Small bits of content which are explained in details, helps me understand the topic, thank you!

    Metal welding

    ReplyDelete
    Replies
    1. hi Diywelding Plans

      since sites has limited space, we have provided the key materials,pls let us know in which topic you need it in details
      1) sheet metal tolerance Standards
      2) Welding Tolerance standards
      3) General Tolerance Standards
      4) V groove Pulley Standard DImensions
      if required in deep or for any queries pls mail us to dansanx@gmail.com

      Delete
  3. What is the international standard used for sheet metal tolerance(table 3.1)?

    ReplyDelete
  4. These type of welders use inert gas because they are non-combustible and do not interfere with the welding process. TIG Welder guides

    ReplyDelete
  5. ahp alphatig is me favorite welding machine using it for 3 years and still working great

    ReplyDelete